Electro-Voice ZX1i-90 Speaker

Electro-Voice ZX1i-90  installation is incredibly simple with the included QuickSAM mounting system. The QuickSAM system is a unique, integrated mounting bracket which is virtually foolproof. It allows the installer to simply snap the speaker onto the bracket, then tighten it to the desired position.

Zx1i uses a special circuit that when in transformer mode the network re-configures itself to a current actuated Hi-Pass filter at the transformer primary. It gently rolls off the lowest frequencies to maintain a safe load on the amplifier without affecting the higher (vocal) frequencies and the program continues without interruption. Low frequency current is limited through the transformer eliminating low frequency saturation. Automatic Saturation Compensation allows many speakers to be run on a distributed line with a 50Hz Hi-Pass filter before the amplifier, regardless of the number of speakers on the same line (the number of tapped watts cannot exceed the amplifier rating). With the same 50Hz Hi-Pass, 10 speakers on transformers will have the same full sound as a single speaker at 8 ohms.

• Integrated QuickSAM Heavy-Duty Strong-Arm Mounting Bracket Included
• Indoor/Outdoor Design - Meets IEC 529, IP44 & MIL810 Environmental Specs
• ASC Automatic Saturation Compensation
• EV8L 8" Weatherized Cone High-Output LF Transducer
• DH2005 1" Exit True Compression Driver
• 90° x 50°Coverage Patterns
• Rotatable Horn Design
• 200W Continuous, 800W Peak Power Handling
• High Sensitivity, 123 dB Maximum SPL